Skip to main content

Reconnect Flow to Source Data

After you import a flow into a new project or workspace, you may need to remap the imported datasets in the flow to source data.

Tip

When you import the flow, you can use the displayed dialog to perform remappings. Use the steps below if you need to perform updates after the import is completed.

When the flow is imported from one instance to another instance, the imported datasets may be broken after the flow has been imported into another instance. You must map the imported flow to the corresponding data sources.

Steps:

  1. Open the imported flow.

  2. In Flow View, the datasets that need remapping have a red dot in the corner of their icon. This dot means that the Cloud Portal is unable to connect to the dataset.

  3. In the Connections page, you may need to recreate the connections that were used to the import the dataset in the original workspace.

  4. For each broken dataset:

    1. Right-click the dataset and clickReplace.

    2. From the Replace dialog, select the existing dataset or click Import Datasets and select the required dataset.

    3. Select Replace.

    4. The selected dataset is replaced with an another dataset.

  5. Repeat the above steps for each broken dataset in the flow.

You may also need to remap the flow's outputs.

In this section: